Skip to main content

RGBWW 100W Controller & Remote - Setup Guide

Set up and operate the RGBWW 100W Controller & Remote. This guide walks you through connecting the controller to your coaxial light sets, pairing the remote, and using the available color modes and seasonal themes.

Emma Sheldon avatar
Written by Emma Sheldon
Updated over a week ago

SKU: CTRLR-100W-RGBWW

Assembled Dimensions: 3.3" x 3.2" x 3.2"; 0.58lbs

What's Included

  • 1x RGBWW 100w Controller

  • 1x RGBWW Remote


Setup Instructions

Step 1: Carefully remove the 100W Controller and Remote from the packaging. Keep the original box for safe storage when not in use.

Step 2: Connect the coaxial end of the controller to your chosen coaxial light set or light cord. Ensure the connection is secure and fully tightened.

Step 3: Plug the power cord end of the controller into a UL-approved outlet or extension cord. Your lights may turn on immediately once power is connected.

Step 4: Test your remote control.

  • If your lights are off, point the remote at the controller and press ON.

  • If your lights are on, press STEADY to begin customizing.

  • Then, select your preferred color or theme button to adjust your display.

Pro Tip: To lock-in a specific color or theme (preventing accidental changes): Press the black button on the side of the controller once to lock. Press it again to unlock and choose a new color or theme.


Remote Control Operation

Initial Setup:

  1. Remove the Remote Control from its packaging.

  2. Reset the RGBWW light:

    • Press the OFF button once.

    • Press the ON button once.

    • Press the Steady button once.

  3. Now the Remote Control is cleared and ready to accept new options.


Remote Control Buttons

Basic Controls:

  • On - Turn lights on

  • Off - Turn lights off

  • Steady On - Solid color mode

  • Wave Function - Wave effect

  • Flashing Out Function - Flashing out effect

  • Flashing Warm White - Flashing warm white

  • Chasing Function - Chase effect

  • Flashing Opal Function - Flashing opal effect

Color Buttons:

  • Red Color

  • Green Color

  • Blue Color

  • Harvest Color

  • Berry Color

  • Aqua Color

  • Opal Color

  • Warm White Color

  • Multi Color

Theme Buttons

Candy Cane Theme:

  1. Chase Red-White-Green

  2. Each color 3 sec.

  3. Red base, white flash

  4. Green base, white flash

  5. Purple base, white flash

Christmas Theme:

  1. Steady Red

  2. Steady Green

  3. Chase Red-Green

  4. Wave Red-Green

  5. Each color 3 seconds

Halloween Theme:

  1. Steady Purple

  2. Steady Yellow

  3. Chase Purple-Yellow

  4. Chase Purple only

  5. Each color 3 seconds

Glacier Theme:

  1. Steady Blue

  2. Steady Teal

  3. Chase Blue-White

  4. Blue base, white flash

  5. Each color 3 seconds


Care & Use

  1. Product is intended for indoor and outdoor use.

  2. Do not mount or place the product near gas or electric heaters, fireplaces, candles, or other similar sources.

  3. Do not use product outdoors in case of extreme weather conditions.

  4. Do not use this product for any other purpose than its intended use.

  5. Do not secure wiring of the product with sharp hooks or nails.

  6. Not intended for permanent installation.

Did this answer your question?